DataStor DataSafe 309200 설치 매뉴얼

{카테고리_이름} DataStor DataSafe 309200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DataStor DataSafe 309200 2 페이지. External-bay tower enclosure kit

Installation Guide

External-Bay Tower Enclosure Kit for 5.25" Drives - VERSION 2

Packing List - Check Contents Prior To Installation:

1) 1 - DataStor External -Bay SCSI Tower Enclosure

2) 1 - 6' AC Power Cord

3) 4 - Removable Plastic 5.25" H/H Front Panels

4) 4 - Rubber Non-Skid Feet

5) 4 - Push Button SCSI ID Select Switches

6) 4 - SCSI ID Cable (from switch to drive)

7) 1 - DataStor Warranty Card

Electrostatic Discharge

Many components on your hard disk are susceptible to electrostatic

discharge. To prevent damage to these components, take careful

precautions before handling your hard disk.

Configuring The Termination

1) DataStor recommends you remove the internal terminators

on the drive, and if termination is required for your setup, use

an external terminator (not included) as shown in Figure 2.

Note: For further information on your hard disk's internal

terminators or removing the terminators please refer to

the hard disk manufacturer's specification guide.

Opening The DataStor Enclosure

1) Using a Phillips head screw driver, remove the the seven (7)

screws securing the cover to the back panel (Figure 3). Do

not remove any screws other than those specified in Figure 3.

2) Carefully slide the cover back until it is free from the front

panel. Then slowly slide the cover upward and away from the

enclosure (Figure 3).

Installation Guide - 7-Bay SCSI Tower Installation Kit - VERSION 2 - Rev 1.0 - March 2000 - 309200 - Page 1 of 2

(MORE)

Figure 1

Figure 2

Figure 3