Aussie 6T01U00SS1 사용자 설명서 - 페이지 10

{카테고리_이름} Aussie 6T01U00SS1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie 6T01U00SS1 20 페이지. Table top grill

Lighting the Grill

To reduce the risk of serious bodily injury or death from fire or explosion:

• Open Hood before lighting the grill to release trapped gas.

• During failed lighting attempts, or if the Burner goes out during operation, turn Control Knob "Off" to dissipate

any accumulated gas. Wait five minutes before repeating lighting procedure.

1. Open the Hood.

2. Push the Regulator Knob in and turn 270 degrees (or 3/4 turn) counterclockwise to the High position (Fig. 2). Note

the triangular indicator mark on the silver regulator housing.

3. Push the Igniter Button in repeatedly until the Burner is lit. Listen for the click indicating spark ignition, and look to

make sure the Burner is lit.

If the Burner goes out during operation, turn Regulator Knob to the "Off" position. Open Hood and wait five minutes

before attempting to relight the grill to allow any accumulated gas to dissipate.

If Burner fails to light after three to four attempts, turn Regulator Knob to the "Off" position and allow any accumulated

gas to dissipate. Check for igniter spark by pushing igniter button and looking at the igniter tip. If no spark, adjust gap

between electrode tip and burner to 3/16" (Fig. 3). If still no spark, see Troubleshooting Section.

Wait five minutes; then repeat the lighting procedures.

The Burner can also be lit manually, see Manual Lighting of the Grill on next page.

Should you notice that your Burner is getting hard to light or the flame is not as hot as it once was, refer to the "How

to Clean your Burner" to remove any possible obstructions.

Regulator Control Knob

Fig. 2

Fig. 3

If no spark, adjust gap between

electrode tip and burner to 3/16"

in OFF position

Triangular Indicator Mark

3/16" gap

WARNING

Regulator Control Knob

in HIGH position

Regulator Control Knob

in LOW position