Aussie 6T01U00SS1 사용자 설명서 - 페이지 4

{카테고리_이름} Aussie 6T01U00SS1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie 6T01U00SS1 20 페이지. Table top grill

Remove grill and all packaging materials from the carton and place on a clean level surface. Some parts are packed

inside the grill body. Remove, unpack and inspect these parts as well.

NOTE: Before using your grill, read the instructions and your manual.

For easier set-up and assembly, follow instructions of each step in the order they are written as you look at the dia-

grams. If accessories mentioned in certain assembly steps do not come with your model, skip that step and proceed to

the next step that applies to your model.

If you have any questions or need help, go to www.aussiegrills.com or contact Customer Service at 1-800-251-

7558. Be sure to have the grill model number and serial number printed on the label located on the inside surface of the

rear leg. If you need replacement parts, look in the Parts List Section to find the exact parts you need. If you need a

replacement part under warranty, a proof of purchase will be necessary. You will be asked to forward your

proof of purchase via e-mail to [email protected] or to fax your proof of purchase to 423-639-1055 and reference

your model and serial number. It is important to register your grill and retain your receipt.

Insert the end of the regulator valve nozzle into the open end of the burner tube (venturi). Align the holes in Regulator

Housing with the threaded holes in the grill firebowl and insert two 5/32 x .31" Bolts through the holes in the housing

into the threaded holes in the firebox. Tighten the bolts securely.

Preparation for Assembly

View shown without

Housing for clarity

Burner Venturi Hole fits

centrally around Regulator

Valve nozzle.