4next EasyLog 빠른 시작

{카테고리_이름} 4next EasyLog에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. 4next EasyLog 2 페이지.

2. Quick start

1.1 Cabling and connection

The wiring and installation of EasyLogs are very simple.

This guide briefly illustrates how to make electrical connections and settings for initial access.

1.2 SD Card

EasyLog stores the data in a standard "SD card". Insert the SD card with the connectors face toward the silk-screen printed part,

as shown in Fig.1.

The connector is a push-push type: to insert the card, press it until a click is felt. To remove the SD card, press lightly; on click the

card will lift a bit and can be withdrawn. N.B. We always recommend the use of industrial-grade SD cards.

Fig.1 SD Card insertion

3.4 Ethernet

If you are using an ethernet connection to read data from ModBus TCP

devices, insert the jack of the ethernet cable into the appropriate RJ

connector of the EasyLog, as shown in Fig.3.

3.5 Power Supply

Connect EasyLog to a 10-40Vdc / power supply 19-28Vac as in Fig. 4.

There is no polarity to be respected.

Fig.4 Power supply terminal

2. Access and configuration

EasyLog has an integrated WEB server, therefore it is configured

using a standard browser. To access the configuration pages, enter

the EasyLog IP address from the browser of your PC, tablet or smart

phone.

Il dispositivo dal quale ci si connette deve essere all'interno della

stessa rete di EasyLog (Par. 4.1).

2.1 Networ IP address

The default IP address of EasyLog is 192.168.1.100

If your network is of the same IP class: 192.168.1 ..., go to paragraph 4.3, otherwise follow the instructions from point 4.2 to set

the correct IP address.

To identify the IP class of your network, run the IPCONFIG command from the command prompt.

3.3 Serial

If you use the serial port to read data from ModBus RTU devices, connect the RS485 wires

as shown in figure 2.

Fig.2 RS485 Connetor

Fig.3 Ethernet connector

Fig.5 IP address verification on your PC