DVB RBBR-04 설치 매뉴얼 - 페이지 9

{카테고리_이름} DVB RBBR-04에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DVB RBBR-04 20 페이지. Rear bumper

INSTALLATION

MANUAL

STEP 7

The thickness of our bumpers will

not allow you to reuse the outer bezel

cages, so after you install the sensor

into the bezel, using a zip tie, tighten

around the sensor and bezel while

pushing zip tie up against bumper.

You can also utilize a small dab of

silicone between the backside of

the bezel and the front face of the

bumper.

Note: On the DV8 bumper, these should be

oriented down.

STEP 8

For the two center sensors, you will

need to cut back or unpeel the wiring

loom of the bumper wiring harness.

Once the wiring is exposed gently

pull the two center sensors away

from each other. This will create extra

length in the harness needed for all

sensors to reach their install location.

Cover wiring with electrical tape or

sleeve.

855-680-9595

NEED HELP?