Datatek DT-6061 사용자 설명서 - 페이지 7
{카테고리_이름} Datatek DT-6061에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datatek DT-6061 16 페이지. Ip-pad application
페이지 인쇄2
A
P P L I C A T I O N S
The DT-6061 software is composed of two components. One component, called the Platform,
exists to support all applications. The second component is comprised of the individual
application (s) .
The Platform provides Operating System functions, selected interfaces, protocol stacks, SNMP
functions, and system OA&M while each application uses the services of the resident Platform .
2.1 I
C
NPUT
ONVENTIONS
All parameters may be given on the command line. Parameters of the form name=<value> may
be given in any order.
For several complex commands, listed below, missing parameters, or corrections of errors in
given parameters, of the form name=<value> are collected by prompting the console user. The
user responds to a prompt for the name by typing the required <value> followed by newline .
Defaults are supplied in some cases, so the user need only enter newline .
q
Commands may be entered in upper or lower case.
q
Parameters of the form name=value may use upper or lower case for name.
q
Default values, if any, are shown in parenthesis as part of the prompt.
q
Case is preserved for values.
q
When a password is being requested by a prompt, input is not echoed.
q
Backspace erases one character and @ deletes the current line of input. Most commands are
killed by del key.
2.2 L
OGIN
Syntax: login PASSWD=<password>
The login command is used to allow access to the other configuration commands.
The PASSWD parameter is not echo suppressed. However, if the PASSWD parameter is not
provided, the console prompts for a password; the response is echo-suppressed in this case.
If the password is valid, the user is placed in the logged in mode. Once the console user is logged
in , the balance of the commands are accessible.
Note: Every application instance might be assigned a different password.
2.3 L
OGOUT
Syntax: logout
The logout command is only allowed if the console user is logged in . It uses no arguments. It will
set the console to the logged out mode. The console may also be logged out by typing exit or
ctrl-D .
Passwords are up to seven characters in length. The characters are alphanumeric and special
characters are not allowed.
11/01/00
C
O M M A N D S
(The default password is "initial")
Datatek Applications Inc.
7