Frigicoll KAY-S 26 DR8 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Frigicoll KAY-S 26 DR8에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigicoll KAY-S 26 DR8 20 페이지.
페이지 인쇄CAUTION
• Before changing the filter or cleaning, turn off the
unit and disconnect its power supply.
• When removing filter, do not touch metal parts in
the unit. The sharp metal edges can cut you.
• Do not use water to clean the inside of the indoor
unit. This can destroy insulation and cause electri-
cal shock.
• Do not expose filter to direct sunlight when drying.
This can shrink the filter.
Air Filter Reminders (Optional)
Air Filter Cleaning Reminder
After 240 hours of use, the display window on the in-
door unit will flash "CL." This is a reminder to clean
your filter. After 15 seconds, the unit will revert to its
previous display.
To reset the reminder, press the LED button on your
remote control 4 times, or press the MANUAL CON-
TROL button
3 times. If you don't reset the reminder, the "CL" indica-
tor will flash again when you restart the unit.
Air Filter Replacement Reminder
After 2,880 hours of use, the display window on the
indoor unit will flash "nF." This is a reminder to replace
your filter. After 15 seconds, the unit will revert to its
previous display.
To reset the reminder, press the LED button on your re-
mote control 4 times, or press the MANUAL CONTROL
button 3 times. If you don't reset the reminder, the "nF"
indicator will flash again when you restart the unit
CAUTION
• Any maintenance and cleaning of outdoor unit
should be performed by an authorized dealer or a
licensed service provider.
• Any unit repairs should be performed by an au-
thorized dealer or a licensed service provider.
Page 14
Maintenance –
Long Periods of Non-Use
If you plan not to use your air conditioner for an exten-
ded period of time, do the following
Clean all filters
Turn off the unit and
disconnect the power
Maintenance –Pre-Season Inspection
After long periods of non-use, or before periods of fre-
quent use, do the following:
Check for damaged wires
Check for leaks
Make sure nothing is blocking all air inlets and outlets
Turn on FAN function
until unit dries out
completely
Remove batteries from
remote control
Clean all filters
Replace batteries