ADE M400020-01 운영 매뉴얼 - 페이지 8

{카테고리_이름} ADE M400020-01에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE M400020-01 16 페이지. Class iii approved scales electronic chair scales

페이지 인쇄

 Test mode

There are different diagnostic functions for the ADE-MAK in test mode. This is reserved for service personnel

only.

Manipulations to test and configuration modes can revoke the calibration status and will result

in loss of warranty!

Settings

The following functions are available in setting mode:

–

Select the serial interface,

–

Set date, time and consecutive printout numbers.

–

Set print format.

–

Set switching points.

–

Test functions

The setting mode is not designed for the input of metrological parameters. Access the function menu by press-

ing the CLEAR (13) key until TIME appears on the display. Use the key pad (13) to navigate within the menus,

to select numerical values and to increase or lower the values. Press the ENTER key to save the values en-

tered and to return to the super ordinate menu level.

Menus structure of setting mode:

FILTER

SERIAL

Setting date and time

–

Enter the CLEAR key for approx. 4 sec; FILTER appears on the display.

–

Press key "6" six times and TIME appears on the display.

–

Press ENTER key and SHOW appears on the display.

–

Press key "6" one time and HOUR appears on the display.

–

Press ENTER key and set the hours using the arrow keys "2", "4", "6" and "8".

–

Press the ENTER key and set the minutes and seconds.

–

Go back by pressing key "2"; TIME appears on the display.

–

Press key "6" one time and DATE appears on the display like the time entry.

–

Press key "2" two times and EXIT Y appears on the display.

–

Confirm with ENTER and date & time are set.

Positioning of patient

Please ensure for security reasons that all brakes at the wheels are being locked. Move the armrest and foot-

rest in an upright position before the patient is being moved onto the scale. Fold down the armrest and foot-

rest and place the feet of the patient upon the footrest.

After finishing the weighing procedure please make sure, that arm- and foodrest are being moved

again into the upright position before patient stand up again.

Armrest and footrest are not to be used as helping device for getting up from the chair!

They are to be understood as supporting device for arms and legs only in order to allow an ac-

curate weighing procedure!

PROGR

PFORMT

SETPTS

TEST

TIME

Operation

DATE

VERS

M400020-210322-Rev007-UM-e