4O3A Rotator Genius 매뉴얼 - 페이지 11

{카테고리_이름} 4O3A Rotator Genius에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4O3A Rotator Genius 20 페이지.

3.8.3 Single Phase High Range AC Motors

Set DIP switch 1 for your corresponding rotor (A or B) to ON. This configures the rotor to high range.

Supply the AC power for driving the rotor on to the dedicated 3 phase port. This power will be outputted over the

High Range port. Connect your rotor on to the High Range output port as shown on the diagram below.

At least 13.8VDC (up to 48VDC) of additional is needed to power the RG logic and sensors regardless of the AC

power.

Important: Make sure to connect the N (neutral) wire properly to avoid damaging your rotor.

Set DIP switch 1 for your corresponding rotor (A or B) to ON. This configures the rotor to high range.

Supply the AC power for driving the rotor on to the dedicated 3 Phase port. This power will be outputted over

the High Range port. Connect your rotor on to the High Range output port as shown on the diagram below.

Motor shown on the diagram is in a triangle configuration as an example. RG supports both triangle and star

configurations.

At least 13.8VDC (up to 48VDC) of additional is needed to power the RG logic and sensors regardless of the AC

power.

⬆

Back to table of contents

Page 11