Aussie Pumps AB Scud 40 운영자 사용 설명서 - 페이지 8
{카테고리_이름} Aussie Pumps AB Scud 40에 대한 운영자 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie Pumps AB Scud 40 16 페이지. Stainless steel frames, 3,000/4,000 psi
Aussie Pumps AB Scud 40에 대해서도 마찬가지입니다: 운영자 사용 설명서 (16 페이지)
Aussie Pumps
E.
Pressure washing
WEAR PROPER FACE PROTECTION WHEN OPERATING
PRESSURE WASHER!
AB Scud 30: single vario lance.
Low pressure
Fan jet adjustment
For high pressure jetting the black plastic lance
head should be pushed fully in. Rotate the
plastic head to adjust the angle of the spray jet.
When low pressure and high flow is required,
including detergent application, pull the plastic
lance head out until it clicks.
AB Scud 40: dual lance.
For high pressure jetting rotate side grip on dual
lance backwards until it stops. Fine control of
pressure/flow can be made with small
adjustments to the rotation of the grip. On the
single lance There is no pressure adjustment
available on single lance options.
When low pressure and high flow is required,
including detergent application, unwind grip
two complete turns. Adjust the detergent
control on the pump as required.
NOTE: Check the system for water leaks, fuel leaks, oil
leaks, hose kinks, etc. Correct any problems before
proceeding.
Machine is now ready for operation.
8
Aussie AB Direct Drive Super Scud Series ... Operation & Maintenance Manual
F.
NOTE: The detergent injection uses a venturi action
and operates when low pressure is selected on the
gun assembly.
High pressure
For longer hose lengths (over 8m for the AB30 & 10m
for the AB40) the detergent injector will not operate
successfully. Use a foamer lance instead (included
with AB30 hose reel version, otherwise optional).
1. Prepare pressure washer detergent solution as
2. Place detergent siphon tube/filter into solution.
3. Adjust lance to low pressure setting (refer to
4. Apply cleaning solution to a dry surface, starting at
5. Allow time for detergent to activate and then rinse
IMPORTANT; You must flush the injection system
after each use by placing siphon hose into a bucket of
clean water, then run pressure washer in low pressure
for 2 minutes.
HIGH PRESSURE SPRAY CAN PENETRATE
THE SKIN & CAUSE SERIOUS INJURY!
Never point the spray gun at yourself, other people
or animals.
Should the spray penetrate the skin SEEK MEDICAL
ATTENTION IMMEDIATELY!
CEASING OPERATION AS EXCESSIVE BY-PASS CAN CAUSE HEAT
Applying detergent
required by manufacturer.
section E).
lower portion of areas to be washed and work
upward, using long overlapping strokes.
off. DO NOT allow detergent to dry on.
DO NOT RUN EXCESSIVE BY-PASS
SWITCH MACHINE OFF WITHIN TWO MINUTES OF
BUILD UP IN PUMP AND SUBSEQUENT DAMAGE.
EXCESSIVE BY PASS RUNNING VOIDS WARRANTY!!
Feb 2019