ADE M50010 운영 매뉴얼 - 페이지 4

{카테고리_이름} ADE M50010에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE M50010 12 페이지. Electronic wheelchair scale, class iii approved

Your ADE Electronic Wheelchair Scale is a class III approved scale which has been manufactured for

medical use in hospitals, by doctors or medical specialists as well as in rehabilitation centres or

nursing homes.

The scale is used to evaluate the weight of patients sitting in a wheelchair, able to walk on their

own or by using any kind of walking aid or lying on an emergency litter. Due to its high

capacity the scale is also used for adipose patients.

The scale is a precision instrument for medical use.

The weighing result is used as an essential basis for medical application decided by doctors or

medical personnel in hospitals, nursing homes, rehabilitation- and dialysis centres.

In order to achieve the best possible results kindly read and follow the Operating Manual in all

respects.

Platform Scale equipped with 1 ramp

Indicator and cable with jag connector system

Mains adapter

Operating Manual including Certificate of Conformity

Attention

Carefully check identity of the serial numbers on the platform and the indicator which is

mandatory for medical use of the scale.

By mains adapter (12V 300mA) and rechargeable batteries (power-pack).

The battery pack is already installed in the display.

Charge the power-pack by using the mains adapter and connect the jack firmly to the display.

Complete first charging of power-pack needs 24 hours.

If scale is used on batteries and display shows Lo power-pack needs to be recharged.

Please make sure the local voltage supply corresponds to the indication printed on the

adapter.

Place the scale on a level surface.

Make sure all four feet underneath the platform have direct contact to the floor.

The spirit level of the scale (next to the handle) is an additional tool to make sure the scale is

perfectly positioned and offers best results when the air bubble is centred.

Connect the display to the platform by using the jag connector.

The alignment of the platform must be checked and corrected if necessary after storage or

every time the location of the scale was changed.

Installation and use of scale

050100-Rev000-M50010