ADE M50010 운영 매뉴얼 - 페이지 7

{카테고리_이름} ADE M50010에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE M50010 12 페이지. Electronic wheelchair scale, class iii approved

Set zero

By using the Zero key eventual irregularities occurred after start up the scale can be compensated by

setting the display back to zero.

Press the Hold key in case of unstable readout which might occur in case of too heavy agitation on

the platform. The scale will hold the result displayed. After leaving the scale the fixed weight is still

displayed and can be noted. Deactivate the HOLD function by pressing the key again.

By using the Units key you may select the weighing mode (kg, lbs, st).

Before cleaning make sure the scale has been disconnected from the socket.

For cleaning just use a damp cloth or common disinfection products.

Do not use any aggressive cleaning fluids.

Make sure no water or cleaning fluid penetrates the scale.

Display indication Lo

Display indication ErrL Check correct positioning of the scale (see chapter installation & use of scale)

Display indication Err

Display indication ErrP Severe failure of weighing system. Please contact your local dealer or service

Do NOT use the scale

•

If the mains adapter shows visible damages

•

If mains adapter is not working properly

•

After long storage in humid places

In those cases contact your local dealer or service partner.

Keep all original parts and pieces for an eventual sending back of the scale in order to avoid any

possible damage during transport which automatically leads to no warranty.

Disconnect all cables before transport to avoid unnecessary damages.

050100-Rev000-M50010

Recharge the power-pack by connecting the mains adapter to the display.

and make sure the scale is completely unloaded.

Function test does not automatically lead to `0.00´. Try zero setting key. If

display still indicates Err the scale needs calibration. Please contact your local

dealer or service partner.

partner.