AUSSIE TONNEAU ATB01018 피팅 지침 - 페이지 4

{카테고리_이름} AUSSIE TONNEAU ATB01018에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSSIE TONNEAU ATB01018 4 페이지. Cover for ford px ranger dual cab (with head board), nov 2011-may 2013

페이지 인쇄

MULTI-FIT SUPPORT BAR

The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all

on the Market, from Suburu Brumbys to Cab Chassis aluminium trays.

Drill, 4mm drill bit

1 x hollow bar centrepiece

2 x solid bar end piece

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with the

holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above and then with a

white pencil make a mark through the small holes of the hollow bar onto the solid ends. This is where you will

drill a hole to the depth of about 1-2mm (do not go any further)

2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you drilled.

Make sure you do not over tighten the grub screws

middle to give it some extra height to assist with water runoff.

BASIC TOOL REQUIRED

MULTI-FIT SUPPORT BAR CONTENTS

FITTING MULTI-FIT BAR

2 x grub screws

. Refit the bar. You may kink the bar in the

Utes