AUSSIE TONNEAU ATR01146 피팅 지침 - 페이지 4

{카테고리_이름} AUSSIE TONNEAU ATR01146에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSSIE TONNEAU ATR01146 4 페이지. Continuous rope tonneau cover

3.3 FITTING MULTI-FIT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders

with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above

and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.

This is where you will drill a hole to the depth of about 1-2mm (do not go any further)

2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you

Make sure you do not over tighten the grub screws

drilled.

bar in the middle to give it some extra height to assist with water runoff.

. Refit the bar. You may kink the