Dvent AW870 설치 및 운영 지침 매뉴얼 - 페이지 5

{카테고리_이름} Dvent AW870에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dvent AW870 6 페이지. 900 mhz wireless stereo speakers

페이지 인쇄

ETTING

PEAKERS FOR

TEREO

For stereo operation, set the Left/Mono/Right Switch (C) to " Left" on one speaker

and " Right" on the other speaker. For monaural operation at each speaker, set the

Left/Mono/Right Switch to " Mono" on each speaker

Note: If you use one speaker at one location and the other at

different rooms), Advent recommends the "Mono" setting for best sound

reproduction.

OPTIONAL SPEAKER MOUNTING BRACKETS

Optional Speaker Mounting Brackets (T) are available to wall mount your AW870

speakers.

TROUBLESHOOTING

The following troubleshooting guide takes you through some of the more common

problems and corrections associated with the installation and/or operation of a

wireless system.

HECKS

DJUSTMENTS

ROUBLE

Confirm that the Transmitter AC Adapter (0) is inserted into the wall

outlet and the power cord from the AC adapter is firmly connected to

the Transmitter Power Input Jack (I).

Confirm that the speaker is turned " ON" .

Confirm that the Speaker AC Adapter(P) is fully inserted into the wall

outlet and the power cord from the AC adapter is firmly connected to

the Speaker

Input Jack (F).

Power

Check that the " C" cell batteries are fresh and inserted for correct

polarity (t, -).

Check that the audio source (stereo, TV, etc.) is turned on and

providing sound as it normally should.

Check that the speaker volume (D) is turned up.

ONAURAL

PERATION

another location (i.e. two

Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com

If you are using a Tape 2 Monitor output from your receiver/amp as

the audio output, check that you have pressed the Tape Monitor/Tape

2 button on the front of the receiver. This will turn on the Tape 2

outputs, which may be inactive otherwise.

Check the left/right balance control on the audio source.

Speaker

If using battery power, batteries may be low. Replace if necessary.

Distortion/

Check that the speaker Tuning Indicator Light (A) is illuminated

Static

green. If not, adjust the Tuning Control Wheel (B) until the light

changes from red to green.

Check that the transmitter Audio Level Indicator Light(H) is flickering

intermittently. If you are using a fixed output and the tight is on solid,

or if the light is not on at all, adjust the Output Level Control Wheel

that the light flickers intermittently.

If you are using a variable output, make sure the Output Level

Control Wheel (K) is all the way right (as shown under " Adjust the

Transmitter" page 7) and adjust the volume on the audio source up or

down as necessary to make the tight flicker intermittently.

Change the position of the transmitter Frequency Control Wheel (N)

to change the operating frequency. Then, readjust the speaker

Tuning Control Wheel (B) until Tuning Indicator Light (A) changes

color to green.

Try changing the physical location of the transmitter. Locate it as

high and free of obstruction as possible. Avoid placing directly on

top of a TV, if possible.

Try moving the transmitter and

signal through certain materials, such as glass, tile, and metal, can

decrease the effective transmitting distance of the system.

closer together. Sending the

speakers