Aussie Tonneaus ATR01159 피팅 지침

{카테고리_이름} Aussie Tonneaus ATR01159에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aussie Tonneaus ATR01159 4 페이지. Tonneau cover to suit flexiglass tray 2350mm x 1805mm

페이지 인쇄

TONNEAU COVER FITTING INSTRUCTION

TONNEAU COVER TO SUIT FLEXIGLASS TRAY 2350MM X 1805MM

Rivet gun, Drill, 4.5mm Drill Bit, Measuring Tape, Silicon Sealant, Anti-Corrosive Primer, Marking Pencil

1 x Tonneau Cover

1 x Elastic Rope

2 x Support Bar

2 x Aluminium Ropetrack (805mm Long)

1 x Fitting Instruction

Some items in fitting kit may not be needed. All fitting kits are weighed to ensure accurate quantities.

1. INSTALLATION PROCEDURE

Note: Remove swarf and apply rust inhibitor to all drilled holes prior to riveting.

1. Join 2 pieces of rope track with dowel supplied. Place 1 piece of dowel in each end of the joined rope track.

2. Place the rope track with dowel placed in the ends of the rope track on the top edge of the drop sides and

push up against the front vertical edge of the tray. This is to ensure the rope track is at the correct height and

the front bead of the Tonneau cover can slide through from the side. Refer Diagram A.

3. Using a 4.5mm drill bit, drill six holes through the aluminium rope track and into the front face of the tray;

one at 50mm from either edge, with the others evenly spaced between the outer two positions. Remove rope

track and run a bead of silicone along the flat edge of the rope track, then rivet the aluminum rope track into

position.

4. To install your support bar. Measure the inside length of the tray. If you have been supplied 1 bar, halve this

measurement and that is the support bar position. If you have been supplied 2 bars divide the measurement

by 3 and these are the support bar positions. Centrally locate each bar bracket over these positions 5mm

down from the top edge, drill and rivet the bar brackets into place. Repeat for the remaining bar brackets on

both sides of the tray. Fit the Tonneau support bar/s to the bar brackets. (See Multi-Fit Bar Instruction

overleaf)

PART NUMBER: ATR01159

BASIC TOOL REQUIRE

CONTENTS

4 x Bar Brackets

43 x Rivets

27 x Rope Buttons

4 x Dowels