Dveo OnRamp/IP 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Dveo OnRamp/IP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dveo OnRamp/IP 7 페이지.

Network Setup:

1) Unpack your OnRamp/IP, power it up and connect two network cables from the

OnRamp/IP to a switch.

2) Connect your PC to the same switch (alternatively, you could use a crossover

cable between your computer and the OnRamp/IP).

3) The IP address for the OnRamp is on a label on the back of your system, just

above the WAN port. Use this IP address to enter the web interface.

4) At the password prompt, enter admin for username and admin for password.

These are the default security credentials.

5) Go to the "Network Setup" tab (the second from right tab) and configure all the

network adapters on the OnRamp/IP.

NOTE: Some of the web interface sections will only show up if you have purchased

that option.