Agri-Fab 45-0324 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Agri-Fab 45-0324에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-0324 12 페이지. Atv mounted 125 lb. broadcast spreader
Agri-Fab 45-0324에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)

페이지 인쇄

REMOVING THE SPREADER

13. Disconnect the spreader from the vehicle battery by

unplugging the short wire harness from the long wire

harness. The short wire harness may be left permanently

attached to the battery.

14. Remove the ﬂ ow control from the rear rack of the vehicle

if it is attached there.

15. Loosen the knobs on the spreader mounting brackets.

Rotate the clamps fastened underneath the vehicle

rack and lift them up through the rack to remove the

spreader.

Hopper closure plate does not open to

the correct position.

Spreader motor doesn't run.

Spreader motor runs backwards.

Motor runs when switch is shut off.

TROUBLE SHOOTING POINTS

1. Material packed around plate

1. Loose connection in spreader

wiring

2. In line fuse is blown.

3. Loose battery connection

4. Battery is run down.

5. Broken spreader wiring

6. Spreader switch is broken.

7. Spreader motor is broken.

1. Wired backwards to battery.

2. Spreader on-off switch is broken.

MAINTENANCE

CHECK FOR LOOSE FASTENERS

1. Before each use make a thorough visual check of the

spreader for any bolts and nuts which may have loosened.

Retighten any loose bolts and nuts.

CHECK FOR WORN OF DAMAGED PARTS

2. Check for worn or damaged parts before each use.

Repair or replace parts if necessary.

CLEANING

3. Rinse inside of hopper and exterior of spreader and dry

off before storing.

STORAGE

1. Rinse inside of hopper and exterior of spreader and dry

off before storing.

2. Store in a clean, dry area.

1. Clean out around closure plate

1. Check and reconnect.

2. Replace fuse.

3. Tighten battery terminals.

4. Recharge the battery.

5. Replace damaged wiring.

6. Replace the switch

7. Repair or replace motor.

1. Switch wiring at battery terminals.

2. Replace the switch.