Frigicoll BSX190 설치, 운영 및 유지보수 매뉴얼 - 페이지 4
{카테고리_이름} Frigicoll BSX190에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigicoll BSX190 16 페이지. Water heater tanks
페이지 인쇄
•
Thermostatic control device
•
Energy cut-off device (safety cut-off functioned thermostat)
•
Temperature reducing valve, pressure reducing valve or safety relief valve
All equipments which are necessary to limit the water temperature under 95°C, must compliant with
the local regulations.
Safety Valve
: In case of high pressure in the tank, discharges the overpressure.
Expansion Vessel
One-way Valve : Allows fluid moving inside the system on desired direction and avoids the flow back
to the opposite direction.
Filter
: Used to block dirts from the water.
Valve : Used to allow or stop the flow of domestic water into the system
Pump : Enables the circulation of fluid used in the system.
Manometer
: Used to measure the pressure of the system.
Thermometer : Used to measure the temperature of the liquid in the system.
Pressure Reducer
device, an appropriate pressure reducer must be installed to decrease the pressure of water.
Installation Guidelines
•
Products are delivering on wooden pallets. Please remove the pallet before installation to
avoid any move after installation.
•
Installation must be performed by a qualified installer in accordance with local regulations
and laws.
•
Installation should be done according to the diagrams given in this manual.
•
The device must be placed on a proper, non-inclined, smooth grounding strong enough to
carry the load of the tank plus water content weight. The area of installation should be
chosen according to the maintenance and service requirements.
•
The device must be placed in a room or covered area as it is an indoor unit, must be
protected against direct sunrays, wet and windy weather conditions and freezing risk.
•
In order to ensure an efficient operation of the device, it is impotant to make connections
according to the installation schemes. Heating device should be chosen according to hot
water supply needs.
•
If the installation guidelines are not followed and damages occur during the installation
process, product will be out of any warranty.
•
If a proper safety valve is not assembled or incorrectly installed, the product will be out of
any warranty.
•
The place of installation should be protected against fire and flood risk. The warranty
does not cover any product failure caused by external effects.
4
: Absorbs pressure fluctuations that may occur in the system.
: In case the water pressure in the system exceeds the allowed pressure of the