Datavideo MS-2850 사용 설명서 - 페이지 18

{카테고리_이름} Datavideo MS-2850에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datavideo MS-2850 20 페이지. 4 channel upgrade i/o card
Datavideo MS-2850에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지), 사용 설명서 (8 페이지)

페이지 인쇄

Powering On

Each product built into this Mobile Video Studio receives DC power from the PD-2A or PD-6 unit on the rear

of the MS-2850.

Please ensure the PD-2A or PD-6 is fed with either an AC or DC feed before attempting to switch on the MS-

2850.

For more information about the PD-2A or PD-6 please refer to its manual in the binder.

If a product within the MS-2850 fails to start after the PD-2A or PD-6 is switched on please locate the on/off

switch for that product which has not yet started.

For further advice on using a product within the MS-2850 please refer to its manual in the binder.

Powering Off

Before powering off the MS-2850 via the PD-2A or PD-6 on/off switch please ensure the HDR-70 has been

stopped.

Packing Away

Once the external source and camera cabling have been removed from the rear connection plates replace

and secure the rear case cover.

Return the ITC-100 gooseneck mic, any ITC-100 cabling, tally lights and headsets etc to your accessory kit

bag/box.

Carefully lower the 17" TLM-170LM monitor and slide it back into its horizontal 1U shipping position. Please

remember to secure the silver screws so it cannot slide/move when in transit.

Now raise/tilt upwards the SE-2850 Control Panel Keyboard and secure it in its shipping position with the

chained securing bolts.

Now return and secure the front cover and the MS-2850 is ready to be moved.