Agri-Fab 45-03641 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Agri-Fab 45-03641에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-03641 13 페이지. 250 lb. tow broadcast spreader
Agri-Fab 45-03641에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)

페이지 인쇄

18. Assemble the vinyl grip (U) onto the ﬂ ow control arm.

See ﬁ gure 8.

19. Insert the ﬂ ow control arm down through the slot in the

ﬂ ow control bracket. Assemble the small hole of the ﬂ ow

control link (V) to the ﬂ ow control arm using a 1/4" x 1"

hex bolt (E), a nylon washer (J) and a 1/4" nylock hex

nut (G) as shown in ﬁ gure 8. Tighten carefully. The

ﬂ ow control link should be snug but should pivot with

no more than slight resistance.

(V) FLOW

CONTROL

LINK

(small hole)

(G) 1/4" NYLOCK

HEX NUT

(J) NYLON

WASHER

(E) 1/4" x 1"

HEX BOLT

FIGURE 8

20. Assemble the ﬂ ow control arm to the ﬂ ow control

mounting bracket using a 1/4" x 1" hex bolt (E), two

nylon washers (J) and a 1/4" nylock hex nut (G). Tighten

carefully. The ﬂ ow control arm should be snug but

should pivot with no more than slight resistance. See

ﬁ gure 9.

(G) 1/4" NYLOCK

HEX NUT

(J) NYLON

WASHERS (2)

FIGURE 9

(U) VINYL GRIP

(E) 1/4" x 1"

HEX BOLT

21. Hook the double bent end of the ﬂ ow control rod through

the hole in the slide gate bracket located near the bottom

of the hopper. See ﬁ gure 10.

FIGURE 10

22. Place a 5/16" ﬂ at washer (K) onto the other end of the

ﬂ ow control rod. Insert the end of the rod through the

curved slot in the ﬂ ow control mounting bracket and

through the hole in the ﬂ ow control link. Secure with a

5/16" ﬂ at washer (K) and a 3/32" x 3/4" cotter pin (M).

See ﬁ gure 11.

NOTE: You can leave off the second washer if there is not

enough room on the end of the rod.

FIGURE 11

23. Place the adjustable stop (S) into the "ON" end of the slot

in the top of the ﬂ ow control mounting bracket. Secure

with the 1/4" x 3/4" carriage bolt (F), a nylon washer

(J), a 5/16" ﬂ at washer (K) and the nylon wing nut (R).

See ﬁ gure 12.

(K) 5/16"

FLAT

WASHER

FLOW

CONTROL

ROD

(K) 5/16"

FLAT

(M) 3/32"

WASHER

COTTER PIN