Datavideo DAC-10 사용 설명서 - 페이지 3

{카테고리_이름} Datavideo DAC-10에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datavideo DAC-10 10 페이지. Datavideo dac-10: quick setup
Datavideo DAC-10에 대해서도 마찬가지입니다: 빠른 설정 (2 페이지), 빠른 설정 (4 페이지)

페이지 인쇄

1. POWER ON/OFF SWITCH

Turns main power on or off

2. POWER INPUT JACK

Connects to the supplied 12VDC 10 watt power supply

3. COMPONENT Y.U.V. VIDEO INPUT JACKS

Input for Y.U.V. component video from Betacam, DVCPro, DVCam, some DVD players, etc.

4. AUDIO/VIDEO INPUT JACK

Analog Audio/Video input convert to DV output.

Note: You can hook up all the cables onto all video/audio input connectors at same time without

conflicting to each connection

5. AUDIO/VIDEO OUTPUT JACKS

Analog Audio/Video signal output which is converted from DV input.

Note: You can hook up all the cables onto all video/audio output connectors at same time without

conflicting to each connection

6. DV IN/OUT JACKS (Two)

6 pin DV (FireWire, iLink, IEEE 1394) cable, from the DV port of a camcorder, DV Bank,

DV deck, etc.

7. DIP SWITCH MODE SETTING

Please refer to next page the DIP Switch setting.

8. BLACK BURST SIGNAL OUTPUT

Video Black Burst Signal to be used as a sync reference source

9. COMPONENT Y.U.V. OUTPUT JACKS

PLA Mode: Comply to SMPTE spec

NTSC Mode: Comply to Sony Betacam spec