DVIGear DVI-TPS-TX90 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} DVIGear DVI-TPS-TX90에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DVIGear DVI-TPS-TX90 2 페이지. Multiport tps extender
페이지 인쇄8
7
DVI-TPS-TX90 Front View
6
DVI-TPS-TX90 Rear View
5
8
7
DVI-TPS-RX90 Front View
6
DVI-TPS-RX90 Rear View
5
DVIGear • 1059 Triad Court, Suite 8, Marietta, GA 30062 • Tel: 770.421.6699 • Toll Free: 888.463.9927 • Fax: 770.234.4207 • [email protected] • www.dvigear.com
2
1
4
1
4
1. Status Indicator LEDs:
HDCP
VIDEO
2
LINK
LIVE
3
2. IR IN/OUT
3. HDMI IN/OUT
4. TPS IN/OUT
5. Ethernet IN/OUT
6. DC IN
7. RS-232 IN/OUT
8. NORMAL / PROG
Note 1: These units enter Power Save mode when no signal is detected on the input. Normal operation is
2
restored when a signal appears on the input. Power Save mode is not supported with Long Reach firmware.
Note 2: Ethernet ports are designed to connect to 10/100 Ethernet products. Do not connect Ethernet devices to
TPS Input or Output as it may result in damage to the equipment.
Infra-Red Accessories
IR Units
Connector
3
IR Transmitter
IR Receiver
Quick Start Guide
MultiPort TPS Extender
Lit Continuously
Blinking
HDCP encrypted video
signal transmission
—
Video signal
transmission
—
TPS connection
TPS connection
detected and Normal
detected and Power
operation
save mode
Device powered and
ready to use
—
Connect IR Transmitter to IR OUT. Connect IR Receiver to IR IN.
Connect source device to HDMI IN. Connect display to HDMI OUT.
Use a high quality TP cable to connect TPS OUT to TPS IN.
Connect to Ethernet switch and/or devices - see Installation.
Connect AC Power Adapter to either unit, other is powered by TP link.
Connect to Ethernet switch and/or devices - see Installation.
Set to NORMAL position. PROG is only for qualified technical personnel.
Locking DC Plug
Connect to
IR OUT
IR IN
Twist 90° clockwise to lock
DVI-TPS-TX90
DVI-TPS-RX90
Off
No HDCP encryption
No video signal
transmission
TPS connection failed
between TX and RX
(1)
No power supply
or out of order
(2)
(2)
3