Agri-Fab 45-0405 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Agri-Fab 45-0405에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-0405 13 페이지. 125 lb. broadcast spreader owners manual

페이지 인쇄

12. Insert the end of the flow control rod through the slot in

the flow control mounting bracket and through the hole

in the flow control lever. Secure with a 1/8 in. x 3/4 in.

cotter pin. See figure 8.

FLOW

CONTROL

LEVER

FIGURE 8

13. Install the adjustable stop on the slot in the top of

the flow control mounting bracket. Secure with the

1/4 in. x 3/4 in. carriage bolt, a nylon washer, a 1/4 in.

flat washer and the nylon wing nut. See figure 9.

1/4-20 WING NUT (M)

FIGURE 9

1/8 x 3/4 in.

COTTER PIN (K)

FLOW

CONTROL

ROD

45_0382Fig8

1/4 in. WASHER (F)

ADJUSTABLE

STOP (O)

1/4-20 x 3/4 in.

CARRIAGE BOLT (D)

45_0382Fig9

14. Adjust the position of the flow control mounting bracket

(figures 10 and 11):

a. Set the adjustable stop at "5." Latch the flow control

lever against the stop. Verify that the closure plate

has opened about halfway. See figure 10.

b. If closure plate is not open halfway, adjust the position

of the flow control mounting bracket until the closure

plate is open about halfway at "5" and still closed when

the lever is in the "OFF" position. Carefully tighten

the 1/4 in. nylock nuts. Do not deform the slots in the

flow control mounting bracket.

c. Push the flow control lever to the "OFF" position

and ensure the closure plate closes completely.

See figure 11.

1/4 in. NYLOCK NUTS

FIGURE 10

FIGURE 11

POSITION 5

ADJUSTABLE

STOP

45_0382Fig11

ADJUSTABLE

STOP

OFF

45_0382Fig10