DVIGear DVI-5312b 사용자 설명서 - 페이지 7

{카테고리_이름} DVIGear DVI-5312b에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DVIGear DVI-5312b 11 페이지. Dvi splitter repeater
DVIGear DVI-5312b에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

페이지 인쇄

The DVI-5300b series Splitters are functionally identical with the exception of the number of

outputs. All have a single DVI-D input and a +5 VDC power input socket. These connectors as

well as the outputs connectors are arrayed on the rear panel. There are no controls or switches

on any of the units however all units have LEDs that indicate type of signal distributed, HDCP

encryption detection and source synchronization and LEDs to indicate the connection to a

compliant device. Finally, there is no power switch.

4.1

Connecting the Input to the Distribution Amplifier

You can connect any DVI-D or HDMI compliant device's output to the DVI input mark with the

designation of "DVI-D IN". Make certain that the DVI or HDMI to DVI cable is securely plugged

into the source device as well as the DVI Splitter. Always use high quality cable, as short a

length as possible for the best results.

4.2

Connecting the Output to the Destination Devices

Using a high quality DVI or HDMI to DVI cables, connect the DVI-D outputs grouped and mark

with a number and designated as "DVI-D OUT" to a DVI or HDMI compliant display devices.

Make certain that the cables securely plugged in to the Splitter and at the display. Always use

the shortest cable length as possible.

4.3

Connecting the Power

All units are shipped with an External Power Adaptor to convert 100 to 240VAC at 50 or 60Hz to

5VDC 5A maximum. Connect the DC output Cable from the External Power Adaptor to the back

of the unit and then plug the Power Adaptor into an AC receptacle. There is no power switch.

The unit begins functioning as soon as it is plugged into AC power source.

5.0

OPERATING THE UNIT

To use any of the DVI-5300b series DVI Splitters, connect a DVI-D or a HDMI to DVI cable, no

more than 41 feet (12.5 meters) in length, from the DVI or HDMI source to the input of the

splitter. Next, connect the outputs of the splitter to their destination devices using DVI cables no

more than 32.8 feet long (10 meters).* Once the Input and Outputs and External Power Adaptor

are connected, plug the AC adaptor into a receptacle and the splitter will begin to function. A

Power LED on the front of the unit will confirm power is present. Other than connecting cables

and applying power, there are no other operator interventions required with the possible

exception of the EDID switch to the rear of the unit.

*Note: Proper operation of DVI Splitter depends on the use of the highest quality cables

available. DVIGear's SHR DVI or HDMI to DVI cables provide low loss, high bandwidth signal

handling and are the recommended cables for use with all DVI and HDMI products. The

distance specification cannot be guaranteed unless SHR cables are used throughout the

system.

- 5 -