Datavideo TLM-702HD 사용 설명서 - 페이지 12
{카테고리_이름} Datavideo TLM-702HD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datavideo TLM-702HD 16 페이지. 2 x 7 inch hd/sd tft lcd monitor
페이지 인쇄
Calibrating Datavideo Monitors
Perhaps the most important way to make sure that your video really looks as good as it can on other
monitors is to monitor the video during production with a properly calibrated monitor.
For guidance on how to calibrate a Datavideo Monitor using SMPTE colour bars, please visit our
website
http://www.datavideo.info/specs/Datavideo_Calibrating_Monitors.pdf
Tally Light Indication
The TLM-702HD has a tally input connector on the rear of each panel. The Datavideo range of digital
video switchers can provide tally light signals to this connector. The Datavideo range of intercom
systems can also be used to pass on these tally signals.
By closing contacts between Pin 1 and 4, the LIVE or RED LED will be displayed.
When the external signal is high (5V), the LED turns Off.
When the external voltage signal is low, the LED turns On.
By closing contacts between Pin 3 and 4 the STANDBY or AMBER LED will be displayed.
When the external signal is high (5V), the LED turns Off.
When the external voltage signal is low, the LED turns On.
Pin 1:
Pin 3:
Pin 4, 10:
Pin 2,5,6,7,8,9,11,13,14:
Pin 12,15:
Tally In
This D-sub 15pin Female connector can receive tally signals from external
equipment such as a Datavideo digital video switcher.
TALLY LIGHT
Red = Live, Amber = Standby.
Tally RED LED On/Off
Tally Yellow LED On/Off
GND
Not used
Reserved – service only.
12