COOK n DINE TS-120 설치 매뉴얼 - 페이지 2

{카테고리_이름} COOK n DINE TS-120에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. COOK n DINE TS-120 3 페이지. Ultradine table cooktop

페이지 인쇄

ULTRADINE TABLE COOKTOP

ASSEMBLY DIRECTIONS

graphic 1

graphic 2

graphic 3

Phone: 1300 655 031 • 27 Tatura Ave, Gosford NSW 2250 • www.cook-n-dine.com.au

Adjustment nut

MODELS #TS-90 #TS-120 #TS-150

STEP 1

Open the box/remove lid. Tabletop is laying

bottom up in the box. Remove packaging from

threaded rod (packed seperately).

Leave tabletop in the box to protect the surface

from scratching during assembly.

If provided, place metal plate on top of the

heating element enclosure and align the

holes. Insert the threaded rod (nut down) into

the designated centered hole. Turn the rod

clockwise until hand-light and nut is flush with

the heating element. Do not use power tools!

(Graphic 1)

STEP 2

Slide the stand (tube) over the threaded

rod, guiding the rod carefully through the

designated holes in each inner brackets at

either end of the stand/tube. (Graphic 2)

STEP 3

Turn the pedestal disk upside down, position

the designated hole on top of the threaded

rod. Turn pedestal clockwise while supporting

it with your hands until it is firmly connected

with the stand and the top of the table.

STEP 4

Turn the now fully assembled table to its

upright position and level it by rising or

lowering the respective adjustment nuts at the

underside of the pedestal disk. Check voltage

label. Now connect the power cord to table

and then to respective three prong grounded

power outlet.

SILK BRUSHED

SHALLOW DIP

HAND FINISHED

TECHNOLOGY

stainless steel

Manufacturer reserves right to change, alter, update or discontinue

any model without notice. Shown accessories not included.

Page 2

Install Sheet 1 of 2

2 year

1 year

Australia/new zealand sales &

support

commercial

home

w a r r a n t y