Datavideo MCU-100 사용자 설명서 - 페이지 15

{카테고리_이름} Datavideo MCU-100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datavideo MCU-100 18 페이지. Multi-camera controllers for panasonic cameras
Datavideo MCU-100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

Datavideo MCU-100 사용자 설명서

Firmware update procedure

From time to time Datavideo may release new firmware to either add new features or to fix reported bugs in
the current MCU-100 firmware. Customers can update the firmware themselves if they wish or they can
contact their local dealer or reseller for assistance should they prefer this method.
This page describes the firmware update process and it should take approximately 20 minutes total time
to complete.
Once started the update process should not be interrupted in any way as this could result in a non-
responsive unit.
As well as a working MCU-100 you will need:
 The latest firmware update for the AD-1 units and the MCU-100.
 The NuMicro ISP Programming Tool software.
The above items can be obtained from your local Datavideo office.
 USB 2.0 cable with a USB A type connector and Micro USB connector.
 A Windows Vista or 7 computers with USB 2.0 port.
Note: It is best to update the firmware of the AD-1 unit(s) at the same time as the MCU-100.
How to update the MCU-100 firmware
1.
Turn off the MCU-100 power.
2.
USB cable connects the MCU-100 to PC.
3.
Set the five switches
4.
Move
switch up towards (AWB) and at the same time also press the shutter select button in. Hold
both in place.
5.
Turn on the MCU-100 power.
6.
MCU-100 LED display will show "L-x.x", and the PC will find MCU-100 by USB 2.0.
7.
Open "MCU-100_U1" folder on PC.
8.
Delete the bootcode.bin file in "MCU-100_U1" folder.
9.
Copy new xxxxxxxxx.bin file to the "MCU-100_U1" folder. Do not worry about the new file name; the
MCU-100 will amend the file name automatically after reboot.
10.
Reboot MCU-100.
Note: It is best to update the firmware of the AD-1 unit(s) at the same time as the MCU-100.
on the MCU-100 to their middle position.
15