Agri-Fab 45-01764 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Agri-Fab 45-01764에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-01764 13 페이지. 7 cu. ft. farm/yard cart

페이지 인쇄

3. Turn the front angle assembly and bottom panel upside

down as shown in figure 3.

4. Lay the two side angles on the bottom panel so that

the two holes for the axle clamps are closer to the front

angle assembly. See figure 3.

5. Secure both axle clamps to the side angles and the

bottom panel using four M6 x 30 screws, lock washers

and hex nuts. Make only finger tight until axle is

assembled. See figure 3.

HEX

AXLE

NUT

CLAMP

M6X30

SIDE

SCREW

ANGLE

FIGURE 3

6. Secure both side angle assemblies to the bottom panel

using four M6 x 25 screws, flat washers and hex nuts.

Make only finger tight until all four screws are in place,

then tighten securely. See figure 4.

HEX

Ф6

NUT

FLAT

WASHER

M6X25

SCREW

FIGURE 4

ENGLISH

FRONT

Ф6

ANGLE

LOCK

ASS'Y

WASHER

BOTTOM

PANEL

SIDE

ANGLE

7. Stand the cart on its front end with the front angle as-

sembly on the floor. See figure 5.

8. Temporarily place four large flat washers (used on wheel

axle) on the inside of front angle assembly. See figure

These washers act as shims and are just

for assembly purposes. You will remove

them later to use on axle.

BOTTOM

PANEL

LARGE

FLAT

WASHER

FRONT

ANGLE

ASS'Y

FIGURE 5

9. Lay the front panel down onto the front angle assembly,

on top of the four large washers. See figure 6.

FIGURE 6

NOTE

FRONT

PANEL

FRONT

ANGLE

ASS'Y

LARGE

FLAT

FRONT

WASHER

PANEL