Datel TurboFire 사용자 설명서 - 페이지 2

{카테고리_이름} Datel TurboFire에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datel TurboFire 4 페이지. Wireless controller for ps3
Datel TurboFire에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지), 사용자 설명서 (4 페이지)

페이지 인쇄

5. Syncing the Controller

Before you can use the TurboFire Wireless Controller for the first time you need to

sync it with your Xbox 360.

To do this, press the 'Xbox Guide Button' on the front of the controller so that the

player indicator number lights begin to flash continuously. Next press the 'Sync'

button on the rear of the controller so that the player number indicator lights

whilst continuing to flash alternate between the player numbers. To complete the

syncing process, press the 'Sync' button on the front of the machine.

After a few seconds the controller and console will be synchronised and a player

number will be assigned to the controller and displayed on the player number

indicator.

6. Using the Turbo Rapid Fire function

The TurboFire controller is equipped with a unique programmable Turbo Rapid

Fire function that can boost your firepower in any Xbox 360 game. The Turbo

Rapid Fire function has 3 mode settings and can be assigned to wide range of

buttons.

Each of the mode settings allow the Turbo Rapid Fire to run at its fastest speed

but each mode includes a very slight timing difference which is required for some

games.

Step 1: Choose Rapid Fire Buttons

By default, Turbo Rapid Fire is assigned to the Right Trigger button but different

games will use different buttons for actions like jump, shoot, block etc. In order

for you to get the most out of the rapid fire function you can choose exactly which

button or buttons it is assigned to.

To program which buttons will use rapid fire, press and hold the TURBO button

and then any one of the buttons shown in the illustration below. When you have

made your selection, release the TURBO button. Turbo Rapid Fire can be

enabled on the following 8 buttons:

Press one or more of these buttons

LT Button

LB Button

Press and

Hold Turbo

The TurboFire Wireless Controller will remember this configuration until the

batteries become flat or are removed or the process is repeated to configure a

different set of buttons.

Step 2: Enable rapid fire and set the fire speed

After assigning Turbo Rapid Fire to one or more buttons (see previous section)

the Turbo Indicator Light on both handles of the pad will illuminate. This indicates

that Turbo Rapid Fire is running in mode 1. To set the Turbo Rapid Fire to mode

2 or mode 3, tap the Turbo button one or more times.

RT Button

RB Button

Button