Datel TurboFire EVO 사용자 설명서 - 페이지 6
{카테고리_이름} Datel TurboFire EVO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datel TurboFire EVO 11 페이지. For xbox 360
Datel TurboFire EVO에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지)
페이지 인쇄
12.1. Sniper
The TurboFire EVO controller is equipped with a unique programmable Sniper Mode feature
which allows for you to slow down the movement of either analogue stick. In slowing down the
movement of either analogue stick allows for more precise movements, which is an advantage
when playing in a sniper situation which requires accurate aiming.
After entering the TurboFire EVO Menu as detailed under section '10', using the A button select
the Sniper feature image to enter the Sniper configuration screen. If you would like to return to
the TurboFire EVO Menu at any time press the Back button.
X-Axis Left Analogue Stick Slider Bar
Y-Axis Left Analogue Stick Slider Bar
X-Axis Right Analogue Stick Slider Bar
Y-Axis Right Analogue Stick Slider Bar
12.1.1. Configuring Sniper
When configuring Sniper you are increasing or decreasing the speed of the analogue sticks by
adjusting the y-axis and x-axis slider bars for each analogue sticks. The y-axis is up and down
movement, the x-axis is left and right movement. The centre of a slider bar represents the
normal speed of the axis. When moving a slider bar to the left you are slowing down the x-axis
or y-axis. When moving a slider to the right you are speeding up the x-axis or y-axis.
In order to adjust each of the slider bars you need to scroll up or down to highlight the slider
bar which you would like to adjust. Whilst highlighting the chosen slider bar move each of the
sliders left or right. You can use any of the buttons shown in the following illustration:
SNIPER
LX
LY
RX
RY
Use one of these controls
Left Analogue
Stick
Direction
Buttons
Once you are happy with your configuration press the Start button to save the configuration. As
detailed under section '11' you can now activate the feature with your chosen configuration.
12.2. Remap
Button remapping gives you the ultimate control over the TurboFire EVO layout by allowing you
to choose which buttons should be pressed to activate each control.
After entering the TurboFire EVO Menu as detailed under section '10', using the A button select
the Remap image to enter the Remap configuration screen. If you would to return to the
TurboFire EVO Menu at any time press the Back button. As shown in the following illustration,
the Remap configuration screen displays which buttons are assigned to each of the controls.
Programmable Buttons
SNIPER
LX
LY
RX
RY
Right Analogue
Stick