4qd PRO-160-HCV 사용 설명서 - 페이지 5

{카테고리_이름} 4qd PRO-160-HCV에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4qd PRO-160-HCV 16 페이지.
4qd PRO-160-HCV에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

Thermistor Input

Can be used to connect external thermistors to monitor external temperatures.

The Pro-160 will accept a standard hobbyist radio control servo signal directly

from a receiver. The receiver should be connected to pins B, C, and D. Pin D is

linked to pin A by Lk1, this can be removed if a 4 wire radio connection is

required.

The Pro-160 is pre-programmed to work with the majority of radio receivers.

Profiles 7 and 8 are pre-configured for RC single ended and joystick use. But to

get the best results you may need to use the RC learn function to properly match

the Pro-160 to your radio system.

The RDO port can act as a BEC for currents up to 1A. Pin B of the adjacent BEC

port can be used in parallel to increase this to 2A if required.

PRO-160 V2.0 10/19

B & D - Thermistors 2 and 3 should be 4QD

part number 39-B0.

If the Pro-160 detects thermistor[s] it will show

the approximate temperature readings on the

display.

Page 5