4qd PRO-160-HV 사용 설명서 - 페이지 11

{카테고리_이름} 4qd PRO-160-HV에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4qd PRO-160-HV 16 페이지.
4qd PRO-160-HV에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

Notes:

•

If you are not using "Joystick" mode, you should set "Learn max reverse"

to the same value as "Learn max forward". Reverse is then selected by

the reverse switch.

•

Volt mode uses the "Pot learn" function for learning.

17. Power-up options

Power on with SEL pressed enters set-up mode.

Power on with DOWN pressed will start up with profile 1. This is an emergency

start option to be used should a system 'EEPROM' error occur.

18.1

About. Gives information on the model, software version, and serial number.

18.2

Factory reset. Allows the user to reset the Pro-160 to factory settings.

18.3

Firmware update. Allows new software to be installed via the uSD card reader.

Switch off the Pro-160, insert the uSD card containing the new software into the

card holder, and switch on again with SEL pressed.

Navigate through the system settings menu to "Firmware" and then follow

instructions. Remove the uSD card when finished.

The Pro-160 has 4 M5 threaded mounting holes in the baseplate, shown in green

in the diagram below.

PRO-160 V2.3/2 04/20

Page 11