Dateq Musicall MAX8.8D 사용자 설명서 - 페이지 7

{카테고리_이름} Dateq Musicall MAX8.8D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dateq Musicall MAX8.8D 12 페이지.

Control

MRC

WallUnits

The audio source for a zone can be selected by

pressing 'channel +' or 'channel -'. The number of

sources

configuration. By pressing the 'channel +' and 'channel -

' simultaneously, the local audio input will be selected.

• When room combining is active slave zones are not able to select the audio

source. Setting the source is only available for the master zone. Slave zones do

have the possibility to adjust volume.

• On the MAX8.8D en MAX8.16D RDS or meta data can bes end to the wallunit

displays.

Local audio input

Using the local audio input MRA1 or MRA2 an external

MRA

audio source like an MP3 player, microphone, laptop or

mixing desk can be added to the system. The MRA1 is

equipped with a balanced audio input on XLR. This way a

microphone can easily be connected. For connecting a

CD player or other RCA sources a conversion cable must

be connected.

Using the Mic/Line switch the input sensitivity can be

adjusted. Set is to line when line level signal is present.

The MRA2 is equipped with both balanced XLR and RCA line level inputs. Each input

can be independently adjusted making a small mix between line and microphone on

the same input.

The Clip/Ovl LED will blink on overloading the input signal.

and

sequence

depends

Adjusting the volume for a zone is done by pressing

'volume +' or volume -'. By holding the button, volume

can be increased or decreased. Pressing both + and –

buttons at the same time will mute the zone. Paging to

the zone is always available.

the

matrix

MusiCall user manual