Austin Hughes Electronics CyberView RKP217-1601 사용자 설명서 - 페이지 18
{카테고리_이름} Austin Hughes Electronics CyberView RKP217-1601에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Austin Hughes Electronics CyberView RKP217-1601 19 페이지. 2u rackmount lcd monitor keyboard drawer with kvm switch
페이지 인쇄
11.
LCD Troubleshooting
11.1
The LCD does not function, the PC input is operational
•
Ensure that the Power adaptor is securely plugged in at both ends and has power feed from
the supply source; check that the Green led light is on on the adaptor unit
•
Ensure the LCD is on by pressing the key
•
Ensure that the LCD is pulled out past the micro switch threshold
11.2
The message 'Check Cable' appears on the LCD
•
The VGA cable input cable is not connected properly
11.3
The message 'No Sync' appears on the LCD
•
The message indicates that there is no input signals from the PC, make sure the PC is
functioning and that the graphics card is installed correctly
11.4
The message 'Signal out of Range' appears on the LCD
•
This message indicates that the input signal is beyond the LCD capability – The maximum
resolution for the screen is 1024 x 768 at 75 Hz Check PC and Operating System output refer
to step
4.0
12.
KVM Troubleshooting
12.1
The Keyboard does not work after boot up
•
Ensure the PC output is OK by plugging a keyboard (101,102 or 104) directly into the PC
port and testing
12.2
The Mouse is not detected during PC boot routine
•
Ensure the PC output is OK by plugging a PS2 mouse directly into the PC port and testing
•
Avoid moving the mouse whilst switching between KVM ports
•
Avoid switching ports whilst shutting down the PC
•
It is not recommended to reduce the scan time setting of the KVM switch to below 5 seconds
– this may have an adverse effect on the switch recognizing the mouse connection
www.austin-hughes.co.uk
User Manual
.
.
Page 18