CooKing SVIF-CK3.0 기술 매뉴얼 - 페이지 5

{카테고리_이름} CooKing SVIF-CK3.0에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CooKing SVIF-CK3.0 11 페이지. Induction cooker
CooKing SVIF-CK3.0에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지), 사용 설명서 (13 페이지), 기술 매뉴얼 (10 페이지)

페이지 인쇄

During installation:

•

Ensure installation, technical support and inspection are carried out by qualified personnel and that the cooking surface is properly

positioned and is not subject to vibration.

•

The kitchen top must be installed leaving a minimum clearance of 2 mm from the walls. This gap is essential to compensate for natural

thermal expansion; this prescription is applicable also in the case of kitchen tops not fitted with the Cooking System Prime appliance

•

Each pack comes with a small container of white "Pasta Termica" that must be used at the time of installation, spreading the paste on

the three or four sensors at the centre of the magnets. Like the other operations, this important obligatory step is shown in the tutorials

mentioned above.

https://www.cookingsurface.it/public/dwnVideo/15-893-Cooking-Surface-PrimeUninstallation-EN.mp4

•

Note that support brackets, fixed or extendible, for the Cooking Surface Prime system are NOT currently supplied with the unit; we are

currently assessing suitable brackets and will be including them in the near future

•

For installation in-situ, the Cooking Surface appliance must be brought into contact with the slab in the vertical direction, avoiding

sideways movements that cause the sensors to rub against the slab so that they potentially become dislodged. The operation can be

performed manually, if necessary using a jack (see photo) to facilitate the process.

YES

•

Do not apply silicone between the Cooking Prime System appliance and the slab because this would make it difficult to remove the unit

and prevent natural thermal expansion movements.

•

Check that the power supply voltage corresponds to the voltage shown on the appliance label on the underside of the induction hob.

•

The electrical connections must be in compliance with local regulations and must be made by qualified personnel.

Note for the installer: the diameter of the domestic power supply cables must be in compliance with statutory regulations.

YES