Agri-Fab 45-01754 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Agri-Fab 45-01754에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-01754 12 페이지. Explorer poly atv cart
Agri-Fab 45-01754에 대해서도 마찬가지입니다: 수리 부품 (2 페이지)
페이지 인쇄7.
Place the drawbar tongue onto the axle and latch
stand bracket then slide the axle through the wheel
support and drawbar tongue. See figure 4.
FIGuRE 4
8.
Assemble a spacer tube, a 1" flat washer, a wheel
(valve stem facing out) and another 1" flat washer
onto the axle as shown in figure 5. Insert a cotter pin
through the axle, spreading the ends. Fill wheel hub
with grease. Repeat on other end of axle.
IMPORTANT:
Pump grease into grease fittings until it is
forced out through ends of wheel hub.
WHEEL
FLAT
WASHER
COTTER PIN
FIGuRE 5
AXLE
DRAW BAR
TONGUE
LATCH STAND
BRACKET
SPACER
AXLE
TUBE
FLAT
WASHER
9.
Assemble the latch stand plate and the latch stand
bracket to the bottom of the poly tray using four 1/4" x
3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts.
The aligning tab on the bottom of the latch stand
bracket must be towards the rear of the cart. Tighten.
See figure 6.
LATCH
STAND PLATE
LATCH STAND
BRACKET
FIGuRE 6
10.
Place the poly tray down onto the wheel support,
positioning it so that the latch stand bracket snaps
under the latch lock lever. Fasten the tray to the wheel
support using eight 5/16" x 3/4" truss head bolts and
5/16" nylock nuts as shown in figure 7. Tighten.
5/16" NYLOCK
FIGuRE 7
5
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
TAB
1/4" NYLOCK NUT
5/16" x 3/4"
TRUSS HEAD
BOLT
NUT
LATCH LOCK
LEVER