Cookology GH601SS 사용자 설명서 - 페이지 12

{카테고리_이름} Cookology GH601SS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookology GH601SS 19 페이지. Built in gas hob

o The protective covering must be removed from both sides.

o Do not leave a gap in the sealing agent or overlap the

thickness.

o IMPORTANT: Do not use a silicon sealant to seal the

appliance against the aperture. This will make it difficult to

remove the hob from the aperture in future if it needs to be

serviced.

o Place the clamp (B) over the holes that match the size of the

screws. There are one set of screw holes in each corner of the

hob. Slightly tighten a screw (C) through the clamp (B) so

that the clamp is attached to the hob, but so that you can still

adjust the position of it.

o Carefully turn the hob back over and then gently lower it into

the aperture hole that you have cut out.

o On the underneath of the hob, adjust the clamps into a

position that is suitable for your worktop. Then fully tighten

the screws (C) to secure the hob into position.

Gas connection

This appliance must be installed by a competent

person in accordance with the current versions of

the

(Republic of Ireland) Regulations and Safety

Standards or their European Norm Replacements.

following

(A) Sealing strip

(B) Clamp

(United

Kingdom)

ROI