Cookology TCH601 사용 설명서 - 페이지 6

{카테고리_이름} Cookology TCH601에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookology TCH601 16 페이지. 60cm ceramic hob black

 IMPORTANT:

ventilation requirements shown in the drawing

opposite.

 IMPORTANT: There are ventilation holes

around the outside of the hob. YOU MUST

ensure that these holes are not blocked by the

work top, when you put the hob into position

(see drawing opposite).

 IMPORTANT: Do not use a silicon sealant to

seal the appliance against the aperture. This will

make it difficult to remove the hob from the

aperture in future, particularly if it needs to be

serviced.

 Carefully turn the hob back over and then gently lower it into the

aperture hole that you have cut out.

 There are holes on the base or the sides of the hob that you can fix the

four brackets to. There are three holes in each one of the brackets.

 You should place the bracket on the underneath of the hob, in a

position that is appropriate for the aperture that you have cut out.

Using the screws provided, fix the bracket to the hob. These screws

MUST be securely tightened.

Fitting guidelines

The ceramic hob is manufactured to work with one-

phase alternating current.The voltage rating of the

ceramic hob heating elements is 220-240V. Adapting

the ceramic hob to operate with two-phase current is

possible by appropriate bridging in the connection

box according to the connection diagram below. The

connection diagram is also found on the cover of the

connection box. Remember that the connection wire

You

must

observe

the