AUSTRALIAN MADE GREAT MATE 설치 및 설정 지침 - 페이지 18
{카테고리_이름} AUSTRALIAN MADE GREAT MATE에 대한 설치 및 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MADE GREAT MATE 20 페이지. Double swing gate motor kit
페이지 인쇄ENSURE THE SOLAR PANEL IS COVERED AND THE BATTERY DISCONNECTED
The solar panel is to be connected directly to the terminal block from the regulator and NOT to the circuit
board.
Remove the "Dummy" wires and connect the positive and negative solar panel wires to the terminal block
from the regulator (grey / red positive wire - grey / black negative wire). Plug the piggy back spade
connections to the battery terminals on the battery. Note the polarity ( Red, Positive wire to
terminal, Black / Blue Negative wire to Black battery terminal). The board should now be powered and
great care should be taken to avoid shorting out or otherwise damaging the circuit board. Uncover the solar
panel and check the solar regulator yellow LED is glowing. Replace the plastic circuit board cover and
metal motor cover and test.
Solar Regulator
Yellow LED
10 Amp
Safety Fuse
Battery Wires
from Solar
Regulator
Remove Dummy Wires
10 Amp Safety
Fuse holder. Pull
out to check.
Push to click
holder back in.
If the solar panel wires need to be extended then we recommend you use a terminal block / joiner. Place the
terminal block / joiners into a small enclosure for protection and outdoor installation. As a minimum, 1.5mm Twin
Active cable should be used to extend the wires
Solar Panel Wires
POSITIVE
/ BLACK tipped
NEGATIVE
Terminal Block
1.5mm Twin Active Low Voltage
Cable
Solar Panel /
Regulator Wiring
Instructions
.
RED
tipped wire
wire
© 2012 G Force Automatic Gates All Rights Reserved
Terminal Block from solar regulator
Connect solar Panel Wires
to grey /
red
wire NEGATIVE wire to grey /
black wire
Red
Battery Terminal / Piggy
Back Spade Connectors.
Black / Blue wires to black
Negative battery Terminal /
Piggy Back Spade
Connectors
Weather Proof
Enclosure
Red
battery
POSITIVE
wire
wires to
Red
Positive