ADE HANSEAT 300 Series 운영 매뉴얼 - 페이지 6

{카테고리_이름} ADE HANSEAT 300 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE HANSEAT 300 Series 20 페이지. Gravity feed slicers

1) Set the knob "A" with scale division to "0" (zero).

2) Pull the food carriage on the carriage arm "B" as far as possible in the direction of the operator.

3) Lift the remnant holder "C" using the handle "D" provided for this purpose. Place the product

on the food carriage with the machine switched off and lower the remnant holder on or behind

the food. Secure the food using the guide rail integrated in the food carriage. Always make sure

that a small clearance remains between the guide rail and the food so that the food is not

jammed and thus prevents sliding. Tighten the fixing screw to prevent slipping of the guide rail.

4) For safety reasons, the remnant holder is firmly connected to the machine. If the food is longer

than the range of motion of the remnant holder, the latter is placed loosely on top. If the length

of the food exceeds the range of motion of the remnant holder, the latter is placed behind the

food. Set the desired slice thickness using knob "A". Selection of slice thickness can be infinitely

variable between 0 and 15mm.

5) Press the green operating button "E" to switch it on.

6) By firmly holding the handle on the food carriage arm "B", move the food carriage back and

forth to slice the food.

7) After slicing has been completed, switch off the machine using the red stop button "F" and reset

the slice thickness setting knob "A" for safety reasons.

4. USING THE SLICER

Hanseat-210617-Rev008-UM-en