Agri-Fab SUPER 17 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Agri-Fab SUPER 17에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab SUPER 17 12 페이지. Atv cart
Agri-Fab SUPER 17에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)

페이지 인쇄
Agri-Fab SUPER 17 소유자 매뉴얼
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)
Screwdriver
(1)
Pliers
(2)
7/16" Wrenches
(1)
1/2" Wrench
(2)
9/16" Wrenches
(1)
Grease Gun
1. Remove the hardware pack and all loose parts
from the carton.
Be sure the carton is empty
before discarding.
2. Lay out all the parts and hardware as shown on
pages 2 and 3.
DO NOT LEAVE THE CART UNATTENDED IN
UPRIGHT POSITION DURING ASSEMBLY. A
FALLING CART CAN CAUSE PERSONAL INJURY!
PAY CLOSE ATTENTION TO THE STABILITY OF
THE CART WHILE IT REMAINS IN AN UPRIGHT
POSITION. FOR BEST STABILITY, ASSEMBLE
ON A SMOOTH, LEVEL SURFACE.
3. Position cart body halves upright on a smooth
level surface such as a garage floor or a paved
driveway. See figure 1.
4. Assemble halves together using four 1/4" x 3/4"
hex bolts and 1/4" nylock nuts as shown in figure
1. Do not tighten at this time.
1/4" x 3/4" HEX BOLT
FIGURE 1
CAUTION
1/4" NYLOCK NUT
5. Position the tailgate reinforcement bracket on
outside of cart as shown in figure 2. Assemble to
the bottom of the cart body using four 5/16" x 3/4"
truss head bolts and 5/16" nylock nuts. Do not
tighten yet. See figure 2.
6. Position the tailgate guides on the inside of the
cart bodies with guide channels to the front as
shown in figure 2. Assemble using four 1/4" x 3/4"
hex bolts and 1/4" nylock nuts. Do not tighten
yet. See figure 2.
5/16" NYLOCK NUT
FIGURE 2
7. At this time, with the cart body halves pulled
together, tighten the four truss head bolts
assembled in step 5 and then the four hex bolts
assembled in step 6. Leave loose for now the bolts
that were assembled in step 4.
8. Carefully reverse the position of the cart so that it
rests on the end with the tailgate reinforcement
bracket, as shown in figure 3. Proceed with the
assembly steps which follow.
FIGURE 3
4
1/4" NYLOCK NUT
TAILGATE GUIDE
1/4" x 3/4"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
TAILGATE
REINFORCEMENT
BRACKET