AUSTRALIAN MONITOR TXG50 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} AUSTRALIAN MONITOR TXG50에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MONITOR TXG50 9 페이지. Txg series
AUSTRALIAN MONITOR TXG50에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (9 페이지)

페이지 인쇄
AUSTRALIAN MONITOR TXG50 설치 및 운영 매뉴얼
TXG10 shown here
1
2
3
1
Direct 8 Ohm Input
The TXG10 provides direct 8 Ohm connection via
this pair of spring loaded push terminals. When using
the 8 Ohm direct inputs, the 6W terminals should
not be used.
2
6W 100V Input
The TXG10 provides a 6W 100V input via this pair
of spring loaded push terminals. When using the
6W 100V input, the 8 Ohm terminals should
not be used.
3
Mounting Point
This thread point is used to attach the TXG10 to
the wall mounting bracket.
TXG SERIES INSTALLATION AND OPERATION MANUAL

REAR PANEL

TXG50 shown here
4
Voltage Tap Select Switch
This switch provides screw driver selection of the
desired 100V transformer tap or the 8 Ohm low
impedance transformer bypass option.
5
Speaker Input
Speaker input is via a pair of colour coded binding
post terminals. The black terminal is negative, the red
terminal is positive.
6

Mounting Points

The wall bracket may be fitted to the mounting points
concealed by the plastic bungs fitted.
Remove these bungs prior to installing the wall bracket.
6
4
5
6
PAGE 5