Cookshack FEC120 운영자 매뉴얼 - 페이지 12
{카테고리_이름} Cookshack FEC120에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookshack FEC120 17 페이지. Fast eddy oven
페이지 인쇄
- 1. Table of Contents
- 2. General Instructions
- 3. Installation Instructions
- 4. Exhaust Systems
- 5. Operating Instructions
- 6. Control Panel Operation
- 7. Loading Instructions
- 8. Shut down Procedures
- 9. Safety Tips
- 10. Maintenance
- 11. Electrical Speciffications
- 12. Trouble Shooting Guide
- 13. Warranty
- 14. National Service Policy
- 15. Electrical Wiring Diagram
- 16. Smoker Illustration
Fire does not light
Excessive pellet feed
Pellet hopper empty
Switch on pellet hopper not in
contact with lid
Dirty combustion pot
Trouble with igniter
Not enough intake air
12
Pellet auger not cycling, call
Customer Service.
Inspect hopper and clean
pellet dust out and fill with
pellets.
Clear pellets so lid will fully
close or adjust switch to make
contact with closed hopper
lid.
Open fire box and clean
combustion pot and try to
restart unit.
Open pellet hopper lid (stops
pellet feed). Push start button.
Open fire box and feel over
pot If hot igniter is ok, if cold
call Customer Service. Can
manually light—see
procedure in start up section.
Check air intake air fan—if
not turning call Customer
Service
If fan turning, refer to
installation instruction and
verify that vent pipe is
properly installed