AUSTRALIAN MONITOR MX82 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} AUSTRALIAN MONITOR MX82에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MONITOR MX82 12 페이지. 8 channel stereo mic/line mixer

CHANNEL INPUTS

Channels 1 to 4 are mic/line switchable XLR balanced inputs. It accepts mic

or line level signals depending on the gain switch position. The XLR will

also have +15V phantom power if selected on the switch accessed through

the lid, see Internal Adjustments.

DIRECT OUT

A unique feature of the MX82 is the individual direct output available for

each of the ﬁ rst 4 channels. The direct outputs are accessed via balanced

TRS 1/4" sockets for each channel. The level of each output is

0dBu (nominal). The signal from any of the four channels can be

disconnected from the main left/right outputs, see Internal Adjustments.

The direct outputs are adjustable to be pre or post the channel level control,

see the Internal Adjustments.

STEREO CHANNEL INPUTS

Channels 5 to 8 are stereo line level RCA unbalanced inputs.

REC OUT

The REC OUT output is on unbalanced RCA connectors. The output is not

affected by the MASTER volume control.

LEFT AND RIGHT OUTPUT

The OUTPUT XLR's provide balanced line level signal of the left and right

bus respectively.

NOTE: When wiring the LINE output as unbalanced, Pin2 should be

wired as hot and Pin1 should be wired as ground/shield.

Do not wire Pin3.

M X 8 2 I N S TA L L AT I O N & O P E R AT I O N M A N U A L

IEC MAINS INPUT SOCKET

This is a standard IEC 3 pin socket. It accepts a standard IEC mains cable,

provided. The fuse draw contains the mains fuse and a spare. The mains

fuse is a time lag (slow blow) HRC 20mm x 5mm ceramic type fuse.

The ratings are:

230V/240V model:

115V model:

IMPORTANT: Always replace the fuse with one of the same value

and type.

NOTE: Always disconnect power to the ampliﬁ er before

replacing fuses.

OPTIONAL MODULE INPUTS

This socket is used with a tone module and/or VCA module.

R E A R PA N E L

63mA

120mA

PA G E 5