Cookson FDO-A10 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Cookson FDO-A10에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookson FDO-A10 15 페이지. Industrial duty fire door operator

CHECK AT THE INTERVALS LISTED IN THE FOLLOWING CHART.

ITEM

Check for excessive slack.

Check & adjust as required.

Drive Chain

Lubricate.*

Sprockets

Check set screw tightness

Fasteners

Check & tighten as required

Bearings/Shafts

Check for wear & lubricate

Gearbox - The gearbox on the motor operator is factory sealed, and non vented, and should not

require service for the life of the operator.

Brake Friction Material - The electromagnetic brake on the motor operator is factory adjusted,

and should not require service for the life of the operator. Should service be

required, the entire unit should be replaced.

* - Use SAE 30 Oil (Never use grease or silicone spray)

Do not lubricate motor. Motor bearings are lubricated and sealed at the factory.

Inspect and service whenever a malfunction is observed or suspected.

CAUTION: BEFORE SERVICING, ALWAYS DISCONNECT OPERATOR FROM POWER SUPPLY.

WHEN ORDERING REPAIR PARTS PLEASE SUPPLY THE FOLLOWING INFORMATION:

PART NUMBER - DESCRIPTION - MODEL NUMBER - JOB NUMBER

ADDRESS ORDER TO:

Operators require practically no special maintenance other than periodic checking to see that

mechanical parts where necessary are lubricated and the electrical components are free of dirt.

The Service Technician should familiarize himself/herself with the proper sequence of operation

and all related controls. Power to operator must be disconnected when removing or replacing

covers on electrical components, making adjustments, or performing maintenance.

MAINTENANCE SCHEDULE

PROCEDURE

COOKSON ROLLING DOORS

2417 S. 50TH AVE

PHOENIX, AZ. 85043

(602) 272-4244

ATTN: CUSTOMER SERVICE

MOTOR OPERATOR MAINTENANCE

EVERY

3 MONTHS

EVERY

6 MONTHS 12 MONTHS