AUSTRALIAN MONITOR ES Series 운영 매뉴얼 - 페이지 6
{카테고리_이름} AUSTRALIAN MONITOR ES Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MONITOR ES Series 17 페이지. Rackmount mixer
AUSTRALIAN MONITOR ES Series에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (13 페이지)
페이지 인쇄REAR PANEL
5
ES250 shown
CH 1-4
1
Each channel input section has two inputs:
XLR input – This is a balanced microphone input with an input sensitivity of 1.2mV.
RCA input – This is an unbalanced line level input. It has an input sensitivity of 160mV. The two RCA sockets are summed to
mono internally.
REC OUTPUT
2
The REC output is on unbalanced RCA connectors. The output level is 220mV into 10kΩ at rated output. The output is dual
mono.
NOTE: The output is not affected by the MASTER volume control or the BASS and TREBLE controls.
The output also does not receive the signal from the tone generator.
LINE OUTPUT
3
The LINE output is on a balanced XLR connector. The output level is 0.775V into 1kΩ at rated output.
NOTE:
The tone generator output will also be fed into the line output if activated.
When wiring the LINE output as unbalanced, Pin2 should be wired as hot and Pin1 should be wired as ground/ shield. Do not wire Pin3.
SPEAKER OUTPUT
4
Speaker connections are provided on screw terminals. 4Ω low impedance and 100V.
IMPORTANT: If you are using the 100V output you must connect the jumper link between 4Ω and OT-IN. (ES60 and ES120)
MINIMUM IMPEDANCE
DISTRIBUTED LINE OUTPUT
100V
LOW IMPEDANCE OUTPUT
NOTE: Only connect one output – either 4Ω or 100V. Do not connect 4Ω and 100V at the same time.
IEC MAINS INPUT SOCKET
5
This is a standard IEC 60320-C14 socket. It accepts a standard IEC mains cable, provided. The fuse drawer contains the
mains fuse and a spare. Consult the specification section for fuse ratings.
Always replace the fuse with one of the same value and type.
PHANTOM POWER
6
12V phantom power is available for condenser or electret microphones on the XLR input when this switch is pushed down.
6
ES SERIES INSTALLATION AND OPERATION MANUAL
4
8
3
ES60
166Ω
4Ω
2
1
ES120
83Ω
4Ω
Always disconnect power to the amplifier before replacing fuses.
6,7
ES250
40Ω
4Ω