AUSTRALIAN MONITOR TX6000 운영 매뉴얼 - 페이지 3
{카테고리_이름} AUSTRALIAN MONITOR TX6000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN MONITOR TX6000 6 페이지. 6 channel mic/line mixer installation series
AUSTRALIAN MONITOR TX6000에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 사양 (2 페이지)
페이지 인쇄AC Power Inlet
The 3 pin IEC power inlet is located on the left side of the rear panel and accepts a standard mains power
lead fitted with an IEC connector. The operating voltage is 115 VAC @ 60 Hz. The AC power voltage is
not externally user adjustable but is factory preset. The inlet is equipped with an inbuilt AC fuse holder
fitted with a 125 mA slow blow fuse plus one spare. Power consumption is 7 VA.
Please ensure that the mains power cord is disconnected before attempting to check or
replace this fuse.
24 Volt DC Power Source Connection
Located to the top right of the IEC power inlet is a 2.1mm DC power socket which provides for the
connection of an external 24 VDC battery. This is ideal for systems where battery backup is required or for
applications where mains power is not available. The centre terminal post or pin is for connection to the
positive (+) terminal. The sleeve is for connection to the negative (-) terminal.
Euro Block Connector
The 7 pin euro connector located on the rear panel allows for the connection of an optional tone module.
The ATC5488 tone module is equipped with 4 tones and a common. The optional module would normally
be fitted inside the mixer with the activation wires and common all connected to the internal header for
easy external activation via switches or third party timers. The euro connector is not connected internally
when supplied from the factory.
Output Connector
The rear panel of the TX6000 includes a male XLR output connector. The output is an active balanced
isolated output for connection to a power amplifier. The maximum output is 1.5V RMS. Pin connections
are Pin 1 = Earth. Pin 2 = Active Positive (+). Pin 3 = Active Negative (-). Note: If an unbalanced output
is required, use a 600 Ohm matching transformer or use only Pin 2 and Earth. Do not short any of the
active outputs to earth.
Tape Output
Two RCA output connectors are included on the rear panel. These provide a line level record output from
the mixer. The tape output provides a maximum of 700mV into 10K ohms making it ideal for connection
to most standard tape recorders. This output is sourced before the master gain control and as such the tape
output level is not influenced by the operation of the master gain control.
Microphone Inputs
The TX6000 includes six female XLR inputs which accept 200 ohm balanced or unbalanced microphones.
Pin connections are Pin 1 = Earth. Pin 2 = Active Positive (+). Pin 3 = Active Negative (-).
Line Inputs
The TX6000 includes six dual RCA inputs for unbalanced line or aux devices such as tape recorders, video
players, tuners etc. Channel 6 has been designed to accept higher level line inputs such as CD players.
When using a CD player with the TX6000, please ensure it is plugged into the channel 6 line input. Dual
RCA connectors are provided to allow for the simple connection of domestic stereo devices such as tape