Agri-Fab 45-03084 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Agri-Fab 45-03084에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-03084 20 페이지. Agri-fab universal tow behind tiller owner's manual

TO REMOvE UNiT FROM

CARTON

• Cut from top to bottom all four corners of the carton

and lay panels flat. (See Fig. 1)

• Remove the lag screw that holds the floating hitch to

the packing skid.

• Disassemble and discard carton's wood top and side

supports.

• Remove four hex bolt, hex nuts and flat washer from

the hold down brackets at the rear of the carton.

• Remove and save the two Flat Washers and Cotter

Pins from the rear axle. Reuse when attaching gauge

wheels.

• Discard all other packing hardware and hold down

brackets.

• Right hand (RH) and left hand (LH) are determined

from the drivers position while seated on the tractor.

• We recommend that you remove the Mower Deck

before using the Tiller. Refer to your Tractor Owner's

Manual.

ASSEMBLY

FiG. 1

TO iNSTALL ThE TiLLER

GAUGE WhEELS

• Assemble Gauge Wheels onto the Rear Axle with the

extended end of Hub facing inward. Secure with the

Flat Washers and Cotter Pins which you removed from

the axle during unpacking. (See fig. 2.)

TO iNSTALL ThE TiLLER TiNE

ASSEMBLiES

• Attach the floating hitch to the tractor's draw bar.

(Refer to Operating Instructions on page 7.)

• Remove the preassembled 3/8" x 2" hex bolt and 3/8"

nylock nut from the L.H. Tine Assembly. Slide the tine

assembly onto the Transmission Axle on the left side

of the tiller and secure with the hex bolt and nylock nut.

(See fig. 3.) Repeat for the R.H. side.

3/8" NYLOCK

NUT

FiG. 2

FiG. 3