AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-15 소유자 매뉴얼 - 페이지 5

{카테고리_이름} AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-15에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-15 12 페이지. Auto self cleaning

페이지 인쇄

1. Ideal Water Quality

My eyes are burning when I swim and I can smell the chlorine strongly.

If your eyes are burning then there is too much chlorine in the pool. You may

be running the chlorinator for too long or your water is out of balance.

Check water balance and adjust as necessary. Possibly reduce the number

of hours you chlorinate the pool (colder months generally require less

chlorination than warmer months).

1. Cell 2. Cell O'ring 3. Cell Housing 4. Cell Nut 5. Chassis 6. Front Panel 7. Lid

8. Mounting Bracket 9. Display Label 10. Brand Label 11. J-Box 12. Pump outlet

13. Transformer 14. Display PCB 15. Power PCB Assembly 16. HVAC PCB 17. Fuse

18. Display Cable 19. Relay cable 20. Mains cable

Page 19

CHLORINATOR OWNER

The Pristine chlorinator unit is designed to be hung on a wall using the included bracket,

between 1 and 1.5 meters above the ground.

The casing is designed with ventilation slots in the bottom to allow cool air to flow up

through the case and out the upper rear ventilation slots. The casing and heatsink

situated to the rear of the unit can become HOT.

Make sure that garden sprinkler systems do not spray directly into, or on to 220/240volt

AC electrical appliances.

Saltwater chlorination is achieved by the electrolysis of brine, which creates both chlorine

and sodium hydroxide (caustic soda). Sodium hydroxide has the effect of raising the pH

level (increases alkalinity).

Check pH once weekly.

IMPORTANT

For the Pristine chlorinator to work efficiently, the pool water should be in optimum

condition (balance).

pH: 7.4-7.6

Under 6.8 and over 8.0, chlorine production is less effective.

Total alkalinity: 120ppm.

Below 80ppm is corrosive, above 150ppm is alkaline and at much higher levels, slimy

and slippery.

Hardness: 200 - 250ppm

When hardness is too high, it forms scale. When hardness is too low, it becomes

corrosive, and etches (eats the surface) concrete pools, or the grout in tile pools.

Stabiliser

Stabiliser is essential in helping to preserve the chlorine produced in the water. Without

stabiliser, the suns UV rays will rapidly deplete the chlorine, regardless of the duration or

power level the chlorinator is run at.

Salt: 6000ppm (6 grams per litre)

In order for the Pristine chlorinator unit to produce 100% of its rated chlorine output,

a salt concentration of 6000ppm (6 grams per litre) is required.

Page 4